Pmod DHB1: Dual H-Bridge Module The Pmod DHB1 uses the Texas Instruments DRV8833 dual H-Bridge motor driver chip to drive two DC motors or a single stepper motor. Each H-Bridge can be driven by GPIO signals. Features Dual H-Bridge capable of 1.5A RMS Two quadrature encoder channels for motor feedback Two JST 6-pin ports for connection to Digilent motor/gearbox Over-current protection Recommended 10.8 V max motor voltage Logic input voltage range of 2.5 V to 5 V Small PCB size for flexible designs 1.3" 1.8" (3.3 cm 4.6 cm) Follows Digilent Pmod Interface Specification Type 5 Shipping Contents One Pmod DHB1 Custom antistatic Pmod packaging Resources & Downloads Resource Center (off-site) Reference Manual (off-site) Schematic
| 