WaterSafe All In One Home Drinking Water Test Kit
Kit test for 8 of the most common & hazardous contaminants in drinking water :bacteria, lead, pesticides, nitrates, nitrites, chlorine, pH and hardness
Contains one bacteria test vial, one lead/pesticide test strip, one nitrate/nitrite test strip, and one pH/hardness/chlorine test strip. Single Use
Tests for ""hard water"", chlorine, bacteria, deadly toxins, pH balance and compare your results to EPA recommended levels
Keep tests out of reach of children or pets. Do not ingest anything from this test kit. Do not drink water sample used for testing.
Store and use at room temperature (60-86 F).Do not use on hot water or water containing bleach detergents. Do not re-use any part of the test kit.
AirFilters.com
This is a WaterSafe All In One Home Drinking Water Test Kit tests for 8 of the most common and hazardous contaminants found in drinking water (bacteria, lead, pesticides, nitrates, nitrites, chlorine, pH and hardness). Use this kit to sample your water and watch the results appear immediately! This kit contains one bacteria test vial, one lead/pesticide test strip, one nitrate/nitrite test strip, and one pH/hardness/chlorine test strip. The kit is comparable to professional lab results in your own home, find out if you have hard water, detect high amounts of chlorine, test for p bacteria, detects deadly toxins, learn your water's pH balance and the ability to compare your results to EPA recommended levels. Keep tests out of reach of children or pets.
Do not ingest anything from this test kit. Do not drink water sample used for testing. Store and use at room temperature (60-86 F).Do not use on hot water or water containing bleach detergents. Do not re-use any part of the test kit.Do not open packets or vial until you are ready to perform the tests.Read and follow all instructions carefully.
Bacteria Test Instructions: Take out the bacteria test vial and set upright on a flat surface, collect water sample or turn on tap to a very slow stream, carefully twist off cap and fill vial to 1/2 inch below the top. DO NOT OVERFILL and DO NOT SPILL the bacterial growth powder in the vial, replace cap and twist on tightly, shake vial vigorously for 20 seconds, place the capped vial upright in a warm area where it cannot be disturbed for 48 hours, after 48 hours, observe the color of the liquid WITHOUT opening the vial.
|
